nubia is all set to launch the Red Magic 6S Pro on September 6 in China. The company has already confirmed that it will be powered by the Snapdragon 888+ chipset. While we are a few days away from the launch, the Red Magic 6S Pro has been listed on the TENAA certification website along with renders and full specifications.
The design is pretty much similar to the Red Magic 6 and 6 Pro. It has a vertical stripe at the middle of the back panel which includes three camera sensors, LED flash, and Red Magic branding. The front design is not clear in the TENAA image. However, it was recently teased by nubia which confirms no design changes than the other Red Magic 6 phones. It also has a thick notch at the top housing the front-facing camera and a couple of sensors.
Nubia Red Magic 6S Pro Specifications
According to the TENAA listing, the device has a 6.8-inch OLED display with 1080×2400 pixels Full HD+ resolution. It will be powered by Snapdragon 888+ SoC which is likely to be coupled with 8GB / 12GB / 16GB RAM and 128GB / 256GB / 512GB storage options.
The triple rear cameras on the back include a 64MP primary sensor, while details about other sensors are not known yet. There’s an 8MP sensor for front photography and video calls. The device packs a 4,380mAh rated capacity battery, likely to have a 5,000mAh typical capacity. The phone is likely to support a 165Hz refresh rate and an under-display fingerprint sensor. It measures 169.86×77.19×9.5 mm and weighs 215 grams.
nubia Red Magic 6S Pro carries model number NX669J-S, which was recently spotted on 3C certification. It revealed that the phone supports 120W fast charging. Recent teasers have revealed that the Red Magic 6S Pro has a 720Hz touch sampling rate, 7.4 ms response time, and is equipped with graphene cooling.